Skip to content

Alkycontrol Corvette C7 MAF KIT

-

Alkycontrol is exactly the kit you need, at precisely the moment when you need it.

With the flood of Injection systems on the market today, and a little research you will notice that most if not all provide systems are based on a 50/50 mix. This is due in part to the higher cost of internal – as well as external parts needed to hold up to 100% “safely”.

When you purchase an Injection system from Alkycontrol you’re getting a product that’s been tested time and time again by some of the fastest out there: cars, trucks, jet skis, airboats, and even a world record holding airplane. If it has a piston/rotor on boost, it will benefit from our injection system.

$749.99

Corvette MAF trigger kit for the C7.

Kit is specifically made for the C7 Corvette application. Typically used with a factory blown C7 like the Z06 or when a roots type blower(Whipple, Eforce, Magnusson) is used. This system uses the OEM washer tank as the methanol tank and triggers based on HZ readings from the Mass Air Flow sensor. Then increases drive to the pump as the frequency increases.

Typically bought as a single nozzle kit M15. Supports 700 RWHP. Upper pulley, exhaust, bolt ons, on 93 octane.

Lower pulley, ported blower, 91 octane, etc.. bought as a twin 10+10 kit. 750 RWHP target.

E85, upgraded supercharger, needs more fuel 10+15, 15+15, etc.. goes up from there. Call if you have any question.

Consult your tuner for his preference on trigger MAF vs MAP. Contact us if you have any question.

Select nozzle in the notes: (additional cost for twin and triple)
M10
M15
Twin 10+10
Twin 10+15
Twin 15+15
Triple 10+15+15
Weight 10 lbs
Dimensions 12 × 10 × 10 in